Dynojet Analog Module Uživatelský manuál stáhnout pdf (Strana 7)

ANALOG MODULE INSTALLATION

Analog Module Installation

Version 1 Analog Module Installation and User Guide

1-3

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

ANALOG MODULE INSTALLATION

This section describes how to access the dyno electronics, install the Analog Module,

route the Analog Module cable assembly, and connect the sensor cables.

CONNECTING AND DISCONNECTING POWER TO THE DYNO

Always disconnect the power before beginning any installation procedures.

Refer to your dyno installation manual for more information on disconnecting the

power to your specific dyno.

1 Use the main breaker to turn power on and off to the dyno.

2 Disconnect the power plug to ensure all power has been removed from the dyno.

ACCESSING THE DYNO ELECTRONICS

You will need to access your dyno electronics in order to add the Analog Module. Use

the following steps to access the dyno electronics.

1 Turn off the main power to the dyno.

To prevent possible injury always disconnect all power to the dyno.

2 Locate the dyno electronics enclosure.

Refer to your dyno installation manual for more information on locating and

accessing the dyno electronics encloser.

3 Remove the twelve screws securing the cover and lift the cover off.

Figure 1-1: Remove Electronics Enclosure Cover

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

Žádné komentáře

Dynojet Analog Module Uživatelský manuál Strana 7