Dynojet Optical RPM Sensor Uživatelský manuál stáhnout pdf (Strana 9)

OPTICAL RPM SENSOR INSTALLATION

Installation

Optical RPM Sensor Installation Guide

1-3

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

INSTALLATION

This section describes the procedures for installing the optical RPM sensor.

CONNECTING THE OPTICAL RPM SENSOR

1 Cut a one inch strip of reflective tape from the roll provided.

2 Clean a flat section of the harmonic balancer. Attach the strip of reflective tape.

Note: High RPM engines will require a longer piece of reflective tape; use a

1.25-1.5-inch strip of tape.

Figure 1-2: Attach Reflective Tape To Harmonic Balancer

3 Attach the optical sensor lead to the hardware stack. You need to remove any

inductive leads from the RPM module if installed.

4 Attach the small power lead from the optical sensor lead to the CPU module.

Figure 1-3: Hardware Stack—Optical Sensor and Power Lead

reflective tape

optical sensor lead

on RPM module

optical sensor power

lead on CPU module

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 21 22

Žádné komentáře

Dynojet Optical RPM Sensor Uživatelský manuál Strana 9